PPPoE stands for Point-to-Point Protocol over Ethernet. It is a network protocol sometimes used by broadband modems for DSL Internet service.

PPPoE allows Internet Service Providers to manage access to accounts via user names and passwords. The username and password is often configured in the DSL modem or router itself and does not require any additional software configuration.

Another distinct characteristic of PPPoE connections is the fact that packets must account for an additional 8-byte PPPoE header, making the maximum packet size 1492, as opposed to 1500.


If you configured PPPoE Dialer in your PC or Wifi Router you will get internet  without asking login page. For that we need to configure our ID and password in our device 1 time it will connect automatic to internet every time.



How to configure PPPoE Dialup on Windows Machines



Follow Below steps for Windows-7 PPPoE Dialup


1. Press start button or press windows button on keyboard and select the Control Panel


2. Select Network and Internet



3. Select Network and Sharing Center


4. Select Set up a new connection or network



5. Select Connect to the Internet



6. Select Set up a new connection anyway



7. Select Broadband (PPPoE)



8. Enter the valid internet ID and Password than click on connect (ID will give by Your ISP)




Follow Below steps to configure Windows-10 PPPoE dialup.  


1. Press Start button or press windows button on keyboard.



2. Select Network and Internet


3. Select Network and Sharing Center


4. Select Setup a new Connection or Network


5. Select Connect to the Internet

    


6. Select Broadband (PPPoE)



7. Enter the valid internet ID and Password than click on connect (ID will give by Your ISP)